Good Evening Gentlemen...I'm a Hanomag/MF Newbie who's having real trouble with my mid 70's Massey Ferguson Hanomag 44C Wheel Loader with about 5k hours. Initially, it had been leaking oil and I assumed it was engine oil but it was not. The next time I started it, it would not move an inch and I have no Getriebe/Gearbox oil pressure, so I shut it down. The Transmission dipstick reads full but I don't know if this is the transmission, gearbox, torque convertor, etc.
Anotherwords, Is this Not the gearbox/transmission that the gage is reading as zero pressure. It's on the left side by where the machine articulates, and there's a sticker saying to check it hot, which I don't want to try now when I have no gearbox oil pressure but it's full on the dipstick, cold anyways. Both the engine and the transmission dipsticks on the left side read full when cold...I really need to find out where the torque convertor, gearbox, or PTO gearboxes are checked, etc as I think it's just low on fluid but don't know which fluids are checked hot/cold and their specific locations.
So My question is, What oil is the gearbox/ transmission pressure gage reading and where do I check and add oil to it on a MF 44C/Hanomag B11C? I'm completely unfamiliar with these loaders and would really appreciate some troubleshooting advice about this G522 converter trans and a G422 powershift 6 speed gearbox ...
Does Anyone Have A Massey Ferguson 44C or Hanomag B11C Service Manual Or Gearbox/Transmission Manual PDF or Paper Copy They'd Like To Sell?
Thanks in advance for any advice, suggestions, or ideas as I'm trying to salvage, or not to ruin this machine.
Anotherwords, Is this Not the gearbox/transmission that the gage is reading as zero pressure. It's on the left side by where the machine articulates, and there's a sticker saying to check it hot, which I don't want to try now when I have no gearbox oil pressure but it's full on the dipstick, cold anyways. Both the engine and the transmission dipsticks on the left side read full when cold...I really need to find out where the torque convertor, gearbox, or PTO gearboxes are checked, etc as I think it's just low on fluid but don't know which fluids are checked hot/cold and their specific locations.
So My question is, What oil is the gearbox/ transmission pressure gage reading and where do I check and add oil to it on a MF 44C/Hanomag B11C? I'm completely unfamiliar with these loaders and would really appreciate some troubleshooting advice about this G522 converter trans and a G422 powershift 6 speed gearbox ...
Does Anyone Have A Massey Ferguson 44C or Hanomag B11C Service Manual Or Gearbox/Transmission Manual PDF or Paper Copy They'd Like To Sell?
Thanks in advance for any advice, suggestions, or ideas as I'm trying to salvage, or not to ruin this machine.