Case 621 What is low pressure regen?
I am familiar with regen in the traditional use where the oil from the rod end is sent to the cap end for more speed. My 621 has low pressure regen at the inlet cover for the loader valve. Can someone...
View ArticleClik here to view.
My Next project - Old Ford A64 Wheel Loader
Today got My next project, old year 1980 Ford A64 wheel loader.. will see how this goes.. :confused: https://www.youtube.com/watch?v=hqTdhqVOJMs Attached Images
View ArticleCase 621B brake pressure light
Brake pressure light and alarm are on. Everything is operating normally. Brakes and trans working fine. Is there any way to disable this light and alarm temporarily until I can get the machine home to...
View ArticleRockwell axle pictures
Delmer, ve tech 63 and excavator Below on the question about the Steerable Rockwell axle; I have some pictures.
View ArticleTrying to save a Hough 65 from the scrap yard
I found a 1974 Hough 65 in my town the loader has sat for about 3-4 years. I was able to get it running today but won't move the oil level is ok. The one thing I noticed is that the driveshaft coming...
View ArticleClik here to view.
Old Ford A64 Wheel loader pushing snow
Today was little bit warmer day and try to push some snow with My old Ford A64 wheel loader.. https://www.youtube.com/watch?v=Sbj2Axz1q28 Attached Images
View ArticleJohn Deere 244j error code
Anyone know what the error code E3011 on John Deere 244j is for?
View Article821c
I am having shift issues. As long as I don't go into F3 all is good. I have checked the wiring harness from tcu, and replaced the harness inside the control valve. All the solenoids had the same ohm...
View Article1985 Cat 920 Sterring Issue
I've got a 1985 Cat 920 wheel loader that I use to plow snow here in Alaska. The steering has always been stiff on it but still responsive, will turn left and right fully. Today after plowing snow I...
View Article544H Transmission R&R labor
Does anybody know how many hours to do a transmission job on a John Deere 544 E-H-J? Thanks
View ArticleCat 950B brakes
Any ideas had to change master cylinder on front brakes and now brakes work but when brake pedal is held for a while brakes let go and machine rolls and has no air leaks
View ArticleCat 962G max modulation current to solenoid valves.
Hello friends, I have a problem with caterpillar sn:3bs00338 (962g). How can i enter calibration mode without control service tool. Thanks in advance. Regards, Artini
View ArticleInternational hough M10A Hub seals??
HI everyone, I have an old International Hough military M10a same as a dresser 530. I am looking for front hub oil seals. Does anyone one have any ideas where to find a good source for parts for this...
View ArticleFR 20 fiat allis
have a friend that has older fr 20 fiat allis loader. just puked the engine, ruining the block. says it has the iveco engine, and is having a HARD time finding a block, plus parts to put back together....
View ArticleCrankshaft sensor volvo l180f
Got some Engine trouble. The display says sid:21-3 i mounted a new crankshaft sensor and still got the error code.but i noticed in the spare parts list that its a shim availible but i didnt see any...
View Article