Working on a 950f loader that has me stumped. Occasionally when shifting into 2nd, the loader doesnt seem to engage the gear. i can flip the neutralizer switch up and back and then she goes. happens in reverse as well.
trans pump shows plenty of pressure, stall test looked good as well.
Installed a new number 5 solenoid last week and shifting seemed improved.
codes: 621f02 downshift signal not correct.
635f06: Speed 2 short to ground
668f02: shift handle signal not correct.
not sure if the codes are active but i can get them to cycle via the dash switch.
In manual, all the gears work but 2nd f or r. seems to happen when warm only.
considering a new column shifter and maybe another solenoid?
thoughts? Thanks in advance.
trans pump shows plenty of pressure, stall test looked good as well.
Installed a new number 5 solenoid last week and shifting seemed improved.
codes: 621f02 downshift signal not correct.
635f06: Speed 2 short to ground
668f02: shift handle signal not correct.
not sure if the codes are active but i can get them to cycle via the dash switch.
In manual, all the gears work but 2nd f or r. seems to happen when warm only.
considering a new column shifter and maybe another solenoid?
thoughts? Thanks in advance.