c3.4 misfire and blues smoke
have a 2012 caterpillar 262c2. it has the c3.4 in it. TMW is the serial prefix. Here is the issue when engine is cold runs perfect starts fine. Once it is at operating temp it will run at high idle...
View ArticleTractomotive TL-20 D, need help finding slip yoke part
Hi folks, New here, saw a few posts by Iceberg I think senior member. He has a loader like mine. I need to find a slip yoke pic of loader and part below. Any help would be greatly appreciated. Thanks...
View ArticleCan anyone tell me what years J.I. Case made the mw24c loader
Cant find any info on the dates of mgf. for the J.I. Case mw24c wheel loader Thanks for any info.
View Articlemichigan # 55/111 tractor shovel/ how can I remove the hyd tank filter, not t...
michigan model # 55 111 tractor shovel . How can I remove the hyd tank filter . It is not the t handel model shown in my parts book. It has a handel and I tried to pull and also twist it with no...
View Articlekomastsu wa 320-3l wheel loader
just got this unit and got engine to run. bucket moes up and down fine but it will not go forward or reverse. shifter lights up as being in 2nd when 1st or 4th. this is in forward and reverse. check...
View ArticleJcb 412s
When called out to check weak steering on loader I discovered that smaller of tandem hyd pump (ultra) was under constant pressure of 90 bar; on further investigation I flow tested both pumps and both...
View ArticleIngersoll Rand WL-440 no start
Machine stop running while in use, Will not restart. The dash doesn't do its full light up and sweep gauges, It just shows a triangle with an explanation point in the middle of it on the display. Stays...
View ArticleNeed help with Old Michigan Loader, whining noise from hydraulics
I am trying to figure out why there is so much whining noise from my loader. The fluid appears to be aerated. I don't know if the noise is because the fluid is aerated or the what is making the noise...
View Articleadd on A/C or find original unit?
I have a JD 544g that I want to put an A/C unit on. I've checked on an add on unit by Red Dot and DTAC and also found an donor machine I could get the original unit off of. Do the originals cool as...
View ArticleWhat are "normal" hours???
Hi all, Bought a 2011 John Deere 244J(compact wheel loader) off a dealer, was used as a landscape material loader...I will use only for snow removal. My question is I bought it with 2,000 hours, not...
View Articleseat setting help 101!
Hi everyone, need a bit of education on seat adjustment. My mechanical Grammar seat, has the lever to adjust your weight etc. my question(s) are these, I am about 195 pounds, do I set this 200lbs?,...
View ArticleCAT IT24F blowing blue smoke
My 1997 Cat IT24F ran out of fuel the other day. Has done it many times as the fuel gauge has never worked since we bought it in 2001... Anyhow, it now feels short on fuel so we changed both fuel...
View ArticleCat it24f steering leak
I have a Cat IT24F wheel loader that is leaking oil out of steering shaft seal. It looks like the orbital motor is removed from under cab. There is a steel plate that is bolted to the cab floor with 3...
View ArticleClark Michigan 35 aws service manual
I am looking for a Clark Michigan 35 aws service manual been looking all over with no luck. This loader has the single ram and the 3-53 Detroit any input is appreciated! Thanks!
View ArticleCase 1840 Loader hydraulics
Figured I would start a new thread. Got the hydraulics working they just do not have any power to lift or tilt bucket when I get much of a load on it say 1/2 bucket full. What if the hoses are...
View Articlemw24c military loader
I bought a JI Case mw24c loader direct from the military. the data plate has a date of 2006 that has been stamped on. The machine was built in 1984. My question, can anyone tell me how to look/tell...
View ArticleClik here to view.
Loader kit for a crane
This is a Fowler crane from the 1940's based on an IH Farmall farm tractor with a front loading bucket attachment. These cranes were built on an assortment of farm tractors in Melbourne. I also found a...
View ArticleConverting M10A forklift to IH 530 loader
The early 1980's military M10A forklift is based on an IH/Dresser 530 wheel loader. It looks to be the same except for the minor military requirements and the addition of the Hyster fork lift...
View Articlewhere to find a quick attach for J.I. Case mw24c loader
Anyone out there know who has a quick attach for a mw24c loader. I use the bucket often and also would like to set it up to load big square bales with a bale spear. Beating those pins out every time to...
View ArticleFuel gage ground problem?
The fuel gage on my loader (JD544A 1973) indicate always "full", maybe the gage is good so I want to check the ground, does anyone know if the ground wire is located on the top of the fuel tank or...
View Article